How to use the ADC-S40-T temperature sensor

: 5+ years

: 1.2 x 1.6 x 0.47" (30.8 x 40.8 x 11.9 mm)

: Z-Wave SmartStart Z-Wave S2 authenticated/unauthenticated

: 14°F to 158°F (-10°C to 70°C)

: 14°F to 113°F (-10°C to 45°C)

: 80% (non-condensing)

: Indoor

: 2AC3T-B36S40TRA

: 12323A-B36S40TRA

This sensor contains a user replaceable coin cell battery (CR2450). If the sensor has reported a low battery or is not illuminating the front LED when the sensor is slid open, replace the battery.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

This equipment has been tested and found to comply with the limits for a Class B digital device, under to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used as per the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.