Factory reset instructions for SmartHome Security devices

Please factory reset until the day of your move and ensure the Control Panel is disarmed

Swipe down and select

Select

Enter 4-digit code: 1234

Select

Select

Scroll down and select

Select when it asks to proceed and reboot the panel

. Locate the back cover for the PowerG Sensor, and remove it. You may need a screwdriver to complete this process

. Find the battery inside the sensor. Carefully remove it. Don't throw the battery away if it is still usable. You will reapply it later

. Take a short piece of wire and connect it across the battery terminal. Hold it in-place for about 5 to 10 seconds. If you don't have a piece of wire, you can hold the metal part of a screwdriver across this area instead. This is done to remove any electrical capacity that may have built up on the battery connectors

. Re-apply the battery you removed earlier. The PowerG device should now be reset, and you should be able to program it with a new system

Tap the button on the face of the outlet 5 times

Press and hold the button for 15 seconds. The LED will increasingly blink faster to indicate that a reset is taking place

Use the wall switch to turn the power to the bulb then four times within four seconds

The Smart LED Light Bulb will flash twice when the reset occurs

Press the button

Select

Select

Select

Select

Select

Press to put the thermostat into mode. When the thermostat is in mode, no symbols are lit below the temperature display

Once in mode, press and hold on the Smart Thermostat until a version displays. The version number does not matter for this process

Once the version displays, press and hold on the Smart Thermostat until displays on the thermostat

When clears from the thermostat display, the thermostat is reset to factory default configurations

Remove battery pack

Press and hold the button while re-inserting the battery pack. Keep holding the button for 30 seconds until the lock beeps and the status LED flashes red

Press the button once more. In 20 seconds, when the LED flashes green and you hear one beep, the lock has been reset

Perform the door handing process again to teach the lock the orientation of the door and add user codes to your lock