Reconnecting your Doorbell Camera to the internet

Hold the main button on your Doorbell and release it when the LED alternates green and red

Log in to the TELUS SmartHome app

Select from the home screen

Select the

Select

Choose your camera type and select

Type a name for your camera and select

Select from the list. Then it will scan for your Wi-Fi network.

If there is a notification that says “Internet may not be available”, allow the camera to connect to the Alarm network. Select

Select your Wi-Fi network from the list and enter the Wi-Fi password. Select

The LED will double-flash orange, then alternate between blue and green for 30 seconds and finally arrive at a solid green. If the LED gets stuck on the double-flash orange mode, then it is likely the Wi-Fi password was entered incorrectly

Configuring your doorbell should take a few minutes to complete

Make sure to and select if you want your doorbell to trigger when the button is pushed and/or when motion is detected

Your video feed should show up under "Doorbell Camera" on your TELUS SmartHome app

Log in to the TELUS SmartHome app

Select from the home screen

Select the and choose the doorbell camera you’d like to remove

Select

Select to confirm