OPTIK TV Restart feature

The on Optik TV allows you to watch programs already in progress or previously aired from the very beginning, even if you forget to set up your PVR.

Optik TV subscribers will be able to use the on select programs that aired up to 30 hours ago.

: You can pause and rewind just like live TV, but there are some channel provider restrictions on . is disabled for all restarted programs.

For a full list of channels that support the visit

OPTIK TV Restart channels list

.

There are several ways to use the :

Using the :

: You can use the in the live TV guide to go back to yesterday: While in the guide, press the button, select , select and press .

Using :

Using :

You can now use the on select previously-aired programs. This new function allows you to:

To get out of mode, change the channel by using your Optik TV remote to press the up or down channel button. Then return back to your original channel. The channel should then operate in regular live TV mode.

: You enter mode by selecting on the green button after selecting a channel with the in the guide.

Click

here

to see Optik Restart channels list.

Yes, you can pause and rewind a program after restarting.

You can pause a program for 10 minutes after restarting. After that, live TV will resume.

This is different from your pause capabilities for live TV and recorded programs. Please visit the

Pause, rewind or fast-forward live Optik TV

support article for more information.

Similar to On Demand content, you cannot record restarted shows. However, you can go back to live TV and record the program from that point on.

Similar to live TV, you cannot fast forward or skip commercials on programming that has been restarted. Restrictions, if applicable, are applied by the channel provider. Fast forwarding is available only on select programming.

: If fast-forwarding is important to you, be sure to use your PVR to set a recording. Visit the

Pause, rewind or fast-forward live Optik TV

support article for more information.

Yes, it is possible to resume programs from where you left off under some conditions. In those cases, the button is replaced by a button.

No, this feature is included with Optik TV at no extra cost.

Depending on the content rights of the next program, you can continue watching in mode or you will return to in-progress live TV.

You may have triggered the on Optik TV by rewinding past the point when you started watching the program. You cannot fast-forward or skip commercials on programming that has been restarted.

: The allows you to rewind up to 30 hours in select previous programming, identified by the icon.

: If fast-forwarding is important to you, be sure to use your PVR to set a recording.

Approximately 5 seconds after tuning in to a channel, the channel peek and the button disappears. You can get it back by pressing the up or down arrow on your remote. Once it appears, press to restart the program.

You can also press the button on your remote once you have tuned in to the channel. You will see an option to . Select it to restart your program.

The on Optik TV allows you to watch programs that previously aired from the very beginning, even if you forget to set up your PVR.

Channels that have Restart content enabled have a left pointing chevron in the guide. Simply use the left arrow on your remote to scroll left "into the past." Select programs on those channels will be shaded lighter in the guide and will have the Restart icon when they are available for you to watch. See

Using the Live TV guide

for steps.

There is currently no option to disable the . You can still watch live TV as normal: Simply ignore the button and it will disappear after a few seconds.

: You can remove the channel peek ( ) that displays the button by pressing the button on your remote while this preview window is visible.